Tirestend to wear unevenly if not rotated regularly. 2004-2009 Mazda 3 common problems: Front end and suspension problems: Rear shock absorbers can leak, causing the rear end of the car to feel 'loose' and bouncy on bumps. The top shock absorber mount can also break off at higher mileage.
Clutchfailure was a common issue on Mazda3’s from 2010 to 2011, failure usually occurred around the 40,000-mile mark and cost an average of $1200 to fix. Some owners even had multiple clutch replacements before they had even reached 6 figures on the odometer. Solution. If your clutch fails the only solution is to have it replaced. 4
Updated July 10, 2021. The OBDII trouble code P0171 - System Too Lean (Bank 1) means that the engine air-fuel mixture is too lean, or there is too much air and too little fuel. Driving a car with the code P0171 can cause more damage to the engine over time, as when the engine runs lean, the combustion temperature is higher.
BadWater Pump Signs: Mazda 6. Here are the most common symptoms of a bad water pump in your 6: 1. Noise. A noisy water pump can indicate that it has a bearing that is going out. The problem with most engine noises is that they are difficult to hunt down.
ProblemDescription. The engine may overheat due to erratic engine cooling fan operation as a result of a faulty cooling fan control module. Replacement of the fan control module would be necessary to correct this condition. Our technicians tell us the Mazda may provide assistance with the cost of this repair. 162 people reported this problem.
For2009-13 Mazda BL Mazda3 Diesel vehicles with 2.2-litre MZR-CD R2 2008 diesel engines, there have been reports of premature engine failures. For these engines, it is understood that the copper seals of the no.1 fuel injector could fail and cause combustion gases to heat the engine oil in the camshaft chambers, creating hard carbon deposits.
My2009 Mazda 6 draws 120mA current continuously when off, all doors closed. This is about 90mA too much. Removing the - Answered by a verified Mazda Mechanic Hi Ellen, I have questions about 2008 Mazda 3, BCM module. The problem is parasitic drain. BCM doesn't go into sleep mode after for a while. Keep drained the vo0N.
  • 6vbsdew7zr.pages.dev/193
  • 6vbsdew7zr.pages.dev/182
  • 6vbsdew7zr.pages.dev/200
  • 6vbsdew7zr.pages.dev/383
  • 6vbsdew7zr.pages.dev/192
  • 6vbsdew7zr.pages.dev/234
  • 6vbsdew7zr.pages.dev/38
  • 6vbsdew7zr.pages.dev/333
  • 6vbsdew7zr.pages.dev/350

    • 2009 mazda 6 common problems